What are they exactly.
Sleepers for the roof.
Rooftop sleeper standoff support.
1 4 6 4 mm minimum gap where the decking meets a solid wall maximum of 3 8 9 5 mm recommended.
It s a wash as the deck keeps the sun off the roof which is good but it also stores a lot of debris in under there.
Sleepers are placed between the deck surface and the ground or slab below it.
It s best to be able to clean it out often.
A set of sleepers supports the decking and allows moisture and air to flow below it.
3 16 4 8 mm gap between boards.
Thanks in advance joe.
Your valley jacks will get nailed to them.
I d put down strips of rubber roof under the sleepers.
The sleeper standoff support offers a strong and economical solution for creating an elevated rooftop standoff from existing sleeper supports or roof curb.
Used to support rooftop water lines gas lines electrical conduit condensate lines and other types of rooftop plumbing.
The building inspector wrote on the elevation plans that we need roof sleepers for our gable dormers.
Roof top deck with sleeper system install guide deck must be designed to ensure that proper drainage and air flow are maintained.
The rooftop sleeper support rss 3 is a rooftop support block or stand that can be cut to desired length using various saws.
This is the standard gapping for duralife products.
They are typically used to elevate piping ductwork hvac equipment walkways pv solar supports and more from rooftops.
You could glue the strips tongue sleepers or just make them a bit wider and rely on pressure to keep them in place.