Now that the bottom of the tailpipe if free from the p trap loosen the nut that connects it to the threaded bottom of the sink drain.
Sink stopper won t seal.
Remove clip from ball rod.
If your sink pop up won t pop up or seat properly fixing it is quite easy usually just a matter of adjusting a few parts.
The photo on the left fig.
Water may leak or refuse to drain around a sink pop up for a number of reasons.
The gasket located under the stopper may also need to be adjusted.
How to fix a sink pop up drain stopper.
Simply remove the plunger clean and if necessary replace.
To reach the stopper the ball rod needs to be removed first.
Re tighten the thumb screw by turning clockwise.
It s easy to fix a bathroom sink drain plug that s leaking.
The clicker may have been over tightened causing the.
Fix a sink stopper.
It moves the stopper in the opposite direction to the lift rod.
Most sink stopper tailpipes are made of pvc and will be connected to the drain with a pvc compression nut that you can loosen by hand.
5 shows the gasket pushed out of position.
A sink stopper with a push pull rod control at the faucet is a great modern convenience.
The photo on the right fig.
But sink stoppers fail.
When you push or pull on the lift rod it activates a lever the extends through the drain tailpiece.
A pivot rod that connects to the back of the drain pipe a perforated strap a clevis and a screw that locks the strap onto the stopper rod.
Find replacement parts on amazon.
Peek above the sink to make sure the stopper is fully closed and that the pop up rod is pushed all the way down 3.
The lever hooks onto the stopper through a hole or hook on the bottom of a long plastic flange that s attached to the stopper.
If a sink won t hold water look up behind the sink with a flashlight if needed to identify the following parts.
Click here for maintenance and service parts.
The ball rod is inserted into the side of the drain and attached with a nut.
A sink stopper mechanism isn t difficult to understand.
Unthread the sink stopper s tailpipe from the underside of the drain.
To remove unthread the rod nut pull the ball rod out and remove the stopper from the drain.
The culprit is often a buildup of hair around the base of the stopper or the pivot rod mechanism.
Gasket to push outward.
If water still does not hold in the sink the next check will be the actual stopper seal.
Remove stopper from drain.
The ball rod holds the stopper in the drain.