I think i m going to fix this.
Shower floor slope fix.
It s on the order of a teaspoon to a tablespoon each shower.
The builder seller is going to fix it.
The picture attached shows the floor you may or may not notice the corner of the shower floor dips a bit and levels off it does not have the proper slope from the corner down to the drain hence my need to build that up a bit to.
After a shower the water may take up.
If that is your case simply tile over tile and create the proper slope while doing so.
I recommend taping off the rectangular area where you stand most.
There is a single drain at the south end but the floor peaks in the middle so half the floor slopes to the drain in the south end but the floor to the north of the middle slopes to the end where there s no drain and water thus pools.
You do a run at 1 4 minimum per foot to the farthest corner.
Was your shower floor never built correctly and no matter what you do there is always standing water that never reaches the drain.
On top is a reviving old thread.
Strike a level line all the way around the shower.
Looking for some advice.
The glass door which swings in and out is centered on the sill and has a plastic deflector at the bottom so the amount of water is not huge.
Mark off the area of the floor that you want to apply the formula.
At the point closest to the drain the slope will be higher than the.
Clean your shower floor or tub thoroughly with a scotch brite pad and dry it completely.
Underneath it is a mortar 1 4 per foot slope to a linear drain.
Shower floors slope tiling in shower recesses the minimum standard required for wet areas in residential buildings is contained in the building code of australia bca and as3740 waterproofing of wet areas in residential buildings.
It s an easy fix with the right tools and products and i can show you how it s done by a tile professional.